| Principle | Chromatographic Immunoassay |
| Format | Dipstick, Cassette, Panel, Cup |
| Specimen | Urine, Hair |
| Certificate | CE |
| Reading Time | 5 minutes |
| Pack | 10T/40T/50T |
| Storage Temperature | 2-30°C |
| Shelf Life | 2 Years |
| Sensitivity | 97.60% |
| Specificity | 99.40% |
| Accuracy | 98.80% |
| Cut-Off | 500 ng/mL*, 1000 ng/mL, 0.2 ng/mg |
Cassette/Dipstick/Panel Ethyl Glucuronide (ETG) urine 500
ng/mL*1000 ng/mL Rapid Drug Abuse Test Kit For The Diagnosis
SUMMARY
Ethyl Glucuronide (ETG) is a metabolite of ethyl alcohol which is
formed in the body byglucuronidation following exposure to ethanol,
such as by drinking alcoholic beverages. Itisused as a biomarker to
test for ethanol use and to monitor alcohol abstinence in
situationswhere drinking is prohibited, such as in the military, in
professional monitoring programs(health professionals, attorneys,
airline pilots in recovery from addictions), in schools, inliver
transplant clinics, or in recovering alcoholic patients.
ETG can be measured in urine by Traditional laboratory methods
(GC/MS or LC/MS) upto approximately 80 hours after ethanol is
ingested (greatly dependent on the amount of alcoholic and
non-alcoholic drinks). ETG is a more accurate indicator of
therecent exposure to alcohol than measuring for the presence of
ethanol itself.
DIRECTIONS FOR CASSETTE USE
Allow the test, urine specimen, and/or controls to reach room
temperature (15-30°C) prior to testing.
1. Bring the pouch to room temperature before opening it. Remove
the test cassette from the sealed pouch and use it within one hour.
2. Place the test cassette on a clean and level surface. Hold the
dropper vertically and transfer 3 full drops of urine (approx.
120μL) to the specimen well (S) of the test cassette, and then
start the timer. Avoid trapping air bubbles in the specimen well
(S). See the illustration below.
3. Wait for the colored line(s) to appear. Read results at 5
minutes. Do not interpret the result after 10minutes.
DIRECTIONS FOR PANEL USE
Allow the test, urine specimen, and/or controls to reach room
temperature (15-30ºC) prior to testing.
1. Remove the test panel from the sealed pouch and use it as soon
as possible.
2. Remove the cap.
3. With the arrow pointing toward the urine specimen, immerse the
test panel vertically in the urine specimen for at least 10 to 15
seconds. Immerse the strip to at least the level of the wavy lines,
but do no touch the plastic device.
4. Replace the cap and place the test panel on a non-absorbent flat
surface.
5. Start the timer and wait for the colored line(s) to appear.
6. The result should be read at 5 minutes. Do not interpret the
result after 10 minutes.
DIRECTIONS FOR DIPSTICK USE
Allow the test, urine specimen, and/or controls to reach room
temperature (15-30ºC) prior to testing.
1. Bring the pouch to room temperature before opening it. Remove
the test dipstick from the sealed pouch and use it within one hour.
2. With arrows pointing toward the urine specimen, immerse the test
dipstick vertically in the urine specimen for at least 10-15
seconds. Do not pass the maximum line (MAX) on the Test Dipstick
when immersing the strip. See the illustration below.
3. Place the test dipstick on a non-absorbent flat surface, start
the timer and wait for the colored line(s) to appear. Read results
at 5 minutes. Do not interpret the result after 10 minutes.
Order Information
| Cat. No. | Product | Specimen | Pack |
| DET-102 | Ethyl Glucuronide (ETG) Rapid Test Cassette | Urine | 40 T |
| DET-114 | Ethyl Glucuronide (ETG) Rapid Test Panel | Urine | 40 T |
| DET-101 | Ethyl Glucuronide (ETG) Rapid Test Dipstick | Urine | 50 T |
| DET-H902 | Ethyl Glucuronide (ETG) Rapid Test Cassette | Hair | 10 T |
